Proper technique is the biggest factor in how long your transfers last. Follow these settings for the best adhesion, sharpest edges, and maximum wash durability.
Cotton Temp
Cotton Temp
Cotton Temp
Cotton Temp
Every step matters. Don’t skip the pre-press or the final press — those two steps alone account for the majority of peeling complaints we hear from shops.
Before placing your transfer, press the bare garment for 3–5 seconds with firm pressure. This removes moisture, wrinkles, and any sizing from the fabric. Skipping this step is the number one cause of poor adhesion and early peeling.
Place your transfer ink-side down on the garment exactly where you want it. Make sure all edges are flat and the design is fully within your platen. Use heat tape on uneven surfaces or curved areas to hold it in place.
As soon as you open the press, peel the carrier film immediately while still hot. Start from one corner and peel back slowly at a low angle. Do not wait — letting the film cool before peeling can cause the transfer to lift with the carrier.
Place parchment paper, a Teflon sheet or a piece of fabric directly over the pressed design and repress. This locks in the adhesive, smooths the surface finish, and significantly improves wash durability. It’s the most skipped step and the most impactful one.
Click a product to get started uploading your design and see why DTF Transfer House is the preferred vendor for screen printers nationwide.